SET-BACK INSTALLATION

J120-G Pump with Set-Back Intake and Univesal Transom Flange and Ride Plate

Only Legend has:

Flange and Suction Piece designed to easily accommodate Transom Angles from 4 to 16 degrees... Transom Gasket for easy disassembly... Flange drilled and tapped for Diverter Fittings... Shift Cable and Cooling Water Fittings thru Flange... O-Ring Cord sealng between Transom Flange and Collar cast on Pump... Side Walls cast on Intake to match Transom cut-out Two Drain Plugs in Intake remove all water from boat... Sealed Oil Reservoir lubricates Tail Bearings... Intake pre-machined for factory Ride Plate

Set-Back Installations move the Engine and Jet back 5 1/2 inches for:

...More Room in the Boat ...Better Weight Distribution and Performance ...Easier and Safer Access to the Clean-out ...Easy Bowl Removal for inspection or Impeller changes

Back to Legend products